Maintenance

Calibrating the Z Offset
In order to get a solid and good looking print is very important that the first layer is printed correctly on the printing surface of the acrylic bed. This...
Mon, 22 Mar, 2021 at 8:57 AM
Replacement: Hot End
Hello and thank you for choosing the Leapfrog Xeed for your printing needs.   The following solution will instruct you on how to replace the Hot end on yo...
Tue, 10 Mar, 2020 at 10:27 AM
Adjustment: Z-sensor probe / solenoid
Hello and thank you for choosing the Leapfrog Xeed for your printing needs. If you notice that even after you use the bed level command and adjust the ...
Tue, 10 Mar, 2020 at 10:25 AM
Connecting to the WIFI network
Hello and thank you for choosing the Leapfrog Xeed for your printing needs. In order to connect the Xeed printer to the wifi network and to find the IP...
Tue, 10 Mar, 2020 at 10:47 AM
How to: open up the printhead
Hello and thank you for choosing the Leapfrog Xeed for your printing needs.   The following solution will instruct you on how to remove filament resid...
Tue, 10 Mar, 2020 at 10:57 AM
How to: unclog the hot ends
Hello and thank you for choosing the Leapfrog Xeed for your printing needs. The following solution will instruct you on how to unclog the hot ends o...
Tue, 10 Mar, 2020 at 10:59 AM
How to: add Filament Temperature Presets
The Xeed 2015 comes with two preheat temperature preset options programmed in the Temperature Tab: ABS and PLA This solution shows you how you can...
Tue, 10 Mar, 2020 at 11:00 AM
How to: align the hot ends
Hello and thank you for choosing the Leapfrog Xeed for your printing needs.   The following solution will instruct you on how to align the hot ends on...
Tue, 10 Mar, 2020 at 11:01 AM
Xeed - Hot end assembly
This solution article will explain how to assemble the Leapfrog Xeed hot end.  Required tools and parts Tools Size Allen key 1.5 Allen Key...
Mon, 8 Nov, 2021 at 12:21 PM