Home Customer support center

Documentation 5

• User Manual
• Safety Information
• Datasheet
• Layout of the Creatr HS Series Electronics
• Hot End - Version Guide

Maintenance 10

• Calibrating the print bed on the Creatr HS (XL)
• Cleaning the print bed
• Cleaning the extruders
• Calibrating the hot ends
• Calibrating offset between extruders on the Creatr HS (XL)

See all 10 articles

Firmware 4

• Software Re-install (User Interface)
• Firmware Update (Motor Control Board) Creatr HS (XL)
• Firmware archive Creatr HS (XL)
• Software Update (User Interface) Creatr HS (XL)

Repair Instructions 39

• Print Head Stops Mid-Print: M999 - Checking the Thermistor and Ribbon Cable - Creatr HS
• Replacement head fans
• How to Install, Repair, or Replace the (Flexible) Filament Gland
• How to Calibrate the Z-Offset of the Creatr HS
• Why is My Creatr HS not Connecting to My PC?

See all 39 articles

3D Models 1

• Fan duct

Software 39

• Simplify3D - Print settings for the Creatr HS
• Simplify3D - Print settings for the Creatr HS XL
• Materialise - Creatr 2.1.0 Creatr (HS)
• Simplify3D - Print settings for the Creatr HS Lite
• Cura - How to Configure Cura - Leapfrog Creatr HS 3D Printer

See all 39 articles

Spare Parts Creatr HS (XL) 1

• Order spare parts